Route Builder Manual Mode No Longer Working
As an MTB'er I use a typical combination of roads and local trails and so I have been using both the standard and the manual route building function on the satellite layer for a few months. However it has now stopped working... Now when I plan a ride the standard road plotting works fine, but as soon as I go to plot part of the route off-road the plot point will only calculate a length of about 10 yards (in real terms) before eventually bring up "Sorry, there was an error, please try plotting the point again". Why? I never experienced this issue before...
Is this a common problem and if so has either Strava resolved this and I have missed a set of instructions, or has anyone found a work around. If all Strava can do from now on is plot where I have been when I am out and about and can no longer be used to plan routes then I think it is time to look for something else.
Just as an additional point this problem only occurred after I had attempted to import a GPX file of a route a friend sent me.
All advice welcome.